“Guru” Water Dump Valve Retention Tool Without Case
Adding cold water to a cold locomotive during cold weather results in the activation of the “Guru” valve, allowing water to drain out of the locomotive cooling system to prevent freeze damage. Our new retention tool prevents the valve from activating, capturing the water until the locomotive has a chance to warm up.
The tool is easily and quickly applied or released with a few turns of the adjusting knob. An eight foot long high visibility cable and magnetic based flashing red LED light are included. The cable is routed to the exterior of the locomotive car body where the red light is applied as a reminder to the operator that the tool is applied.
This part number is just for the tool, cable, and LED light. The part number that includes all of this and the case is 0289-2.
Power Assembly Jewelry Tray$98.50Made of light-weight aluminum, this tray convenientlyfits over the engine block to hold components and toolsduring power assembly change-out.It places everything at a convenient height and centrallocation, simplifying power assembly replacement.14″ wide X 20″ long 1″ deep
Drop Pit Rail Clamp$894.44
BOLT-ON DROP PIT RAIL CLAMPS
Use these clamps to hold a locomotive in place during traction
motor replacement using drop tables.
The clamps are held securely in place
on the rail simply by tightening two bolts. They are not intended
for use as a derail or other method of blue flag protection.
Item # 0253 –1 ( Set Of Four Clamps)
LOCOMOTIVE HAND RAIL HANGERS$246.00
These hangers are made of aluminum and have a rated capacity of 50 pounds each,
They.are used to retain handrail sections after they have been removed from the locomotive.
Two hangers are required for each handrail section,
Two per Set.