6″ Wide Draft Gear Pocket Gauge
This gauge is used to establish the correct gauge dimension of 24 5/8” between the front and rear draft lugs in the draft gear pocket. Magnets hold the gauge in position in the draft arm while the draft lugs are being installed.
Vent Protector Plug Tool (1″ Thread)$49.67
Use this tool to plug the bottom outlet on number 8 vent valves when performing an air test. ( 1″ Pipe Thread ) .The handle is covered with red reflective tape to serve as a reminder to remove the tool after an air test. The “T” handle provides quick, easy installation and removal.
Available with a 3/8″ Pipe Thread. Refer to part number 0336-1.