Manual Draft Gear Assembly Table
$4,149.89
* The Draft Gear Assembly Table is designed to quickly push together any “E” or “F” style draft gears, yokes, and follower blocks. The table offers a safe alternative to handling and assembling these heavy components by hand using bars.
* Handles are attached on the Pusher Arms for manual assembly.
Related products
-
Add to cartMORE INFOSide Bearing Cage Wrench Set
$201.17Side Bearing Cage Wrench Set – The long handle on this wrench set allows simple access to the 1 1/8″ nuts used to secure the Side Bearing Cage to the Truck Bolster. The wrench is equipped with both straight and offset wrench ends to allow access to any fastener configuration.
-
Add to cartMORE INFOVent Protector Plug Tool (1″ Thread)
$82.59Use this tool to plug the bottom outlet on number 8 vent valves when performing an air test. ( 1″ Pipe Thread ) .The handle is covered with red reflective tape to serve as a reminder to remove the tool after an air test. The “T” handle provides quick, easy installation and removal.
Available with a 3/8″ Pipe Thread. Refer to part number 0336-1. -
Add to cartMORE INFO24″ x 36″ Aluminum Jacking Pads (Sets Of Two)
$4,198.92