LATEST PRODUCTS
-
RV AC Unit Lifting Fixture
$2,994.69Used for lifting RV AC unit onto the roof of locomotives. The AC unit rests on top of this fixture while a forklift raises the fixture to the top of the locomotive. The top of the fixture telescopes out to get the AC unit as close to the locomotive as possible. A brake on either side locks the telescoping top in place after it is moved into position. Tie down points are included on the top of the fixture to strap down the AC unit.
-
Wheel Set Lifting Fixture
$2,180.00The wheel set lifting fixture can be used for 33″, 36″ , 38″, wheelsets using overhead cranes or wheel trucks. There are 6 nonmetallic delran pads that are replaceable if needed.
Not to be used for lifting traction motor idler wheel set.
- Fixture Weight 380 Lbs
- WLL 3500 Lbs
- 42” Wide 44” Tall
-
Traction Motor Lifting Dolly
Use this dolly to remove and install traction motors when a drop pit table is not available. The hydraulic arm is able to raise the pivot end of the motor up to 15”. Comes complete with a two-speed hand pump, hydraulic cylinder, gauge, and hose.
Call for Pricing
-
Knuckle And Air Hose Trailer
$4,992.50Use our new trailer to transport knuckles and air hoses around rail yards.
- Holds 8 knuckles, 12 glad hand train line hoses, 8 wide auxiliary hoses, and 9 skinny auxiliary hoses.
- Retaining bars keep air hoses in place while in transport.
- Not for high speed use. Do not use on public roadways.
-
Intermodal Security Bolt Bender
$23.20- Our Intermodal Security Bolt Bender provides a quick and simple method of bending the 3/8″ bolts used on containe security latches to prevent the nut from being removed.
- The 15″ length reduces the effort normally required for bending.
- The handle is knurled to provide a positive grip for the operator.
-
Lift Table Trolley System With Transfer Table
$11,859.71This version of our Lift Table Trolley System includes a Ball Transfer Table that allows two inches of left to right, and twelve inches front to rear movement for component positioning. The ball transfers are sealed and bolted to the table for easy replacement if damaged. The collapsed height is 14 1/2″ and the extended height is 43″.