Slanted Extended Height Draft Gear Cradle
Use this cradle on top of existing lift tables or devices to securely hold the draft gear assembly in place for installation. This cradle is slanted about two degrees to match the angle of the draft gear pocket when the car is jacked from one end. It may also be used to store the draft gear assembly on the floor after it is removed from the car. The design has been changed to allow placement of the carrier plate though the cradle for gear installation. Light weight aluminum construction for ease of handling and transport.
Side Bearing Cage Wrench Set$178.80
Side Bearing Cage Wrench Set – The long handle on this wrench set allows simple access to the 1 1/8″ nuts used to secure the Side Bearing Cage to the Truck Bolster. The wrench is equipped with both straight and offset wrench ends to allow access to any fastener configuration.
Vent Protector Plug Tool (1″ Thread)$49.67
Use this tool to plug the bottom outlet on number 8 vent valves when performing an air test. ( 1″ Pipe Thread ) .The handle is covered with red reflective tape to serve as a reminder to remove the tool after an air test. The “T” handle provides quick, easy installation and removal.
Available with a 3/8″ Pipe Thread. Refer to part number 0336-1.