Showing 190–216 of 484 results
-
Add to cartMORE INFOAir Brake Valve Stud Installation Tool
$98.97This tool is used to install the 5/8”-11 air brake valve studs in the pipe bracket.– The tool hex size is 15/16”, which is the same size as the socket or wrenchused to install for stud nuts.– The internal thrust bearing allows the tool to be easily removed from thestud after it is tightened in the pipe bracket. -
Add to cartMORE INFOEMD Radiator Cap Removal Tool
$159.08This tool is specifically designed to remove and install the radiator caps on EMD locomotive engines.
Rubber grips provide a comfortable, slip resistant surface for the operator.
Provides the leverage necessary to open stubborn caps while keeping the operator’s hand away from hot radiator fluid. -
Add to cartMORE INFOGE Radiator Cap Removal Tool
$159.08This tool is specifically designed to remove and install the radiator caps on G.E. locomotive engines.
Rubber grips provide a comfortable, slip resistant surface for the operator.
Provides the leverage necessary to open stubborn caps while keeping the operator’s hand away from hot radiator fluid. -
Add to cartMORE INFOVent Protector Plug Tool (1″ Thread)
$72.95Use this tool to plug the bottom outlet on number 8 vent valves when performing an air test. ( 1″ Pipe Thread ) .The handle is covered with red reflective tape to serve as a reminder to remove the tool after an air test. The “T” handle provides quick, easy installation and removal.
Available with a 3/8″ Pipe Thread. Refer to part number 0336-1. -
Add to cartMORE INFO
Vent Protector Plug Tool (3/8″ Thread)
$65.94Use this tool to plug the bottom outlet on number 8 vent valves when performing an air test. The handle is covered with red reflective tape to serve as a reminder to remove the tool after an air test. The “T” handle provides quick, easy installation and removal.
Available with a 1″ Pipe Thread. Refer to part number 0336. -
Add to cartMORE INFOLubricated Pad Channel Scraper
$204.92This new tool is used to clean the residue out of the locomotive flange lubricator tracks.- One end of the tool has a knife type blade to remove caked-on lubrication material.
- The other end of the tool has a hook type blade to scrape the loose lubrication material out of the track.
- The handle is knurled on both ends to non-slip gripping surface while using the tool.
-
Add to cartMORE INFOG. E. Exhaust Manifold Clamp Pliers
$66.83The pliers are used to pull General Electric Exhaust Manifold clamps together to allow hand tightening of the exhaust clamp nut. The gripping tines are aggressively knurling to keep a firm grip on the clamp during closure. The tines may be installed on either side of the pliers to accommodate left or right hand applications. They may also be used as a conventional pair of adjustable pliers
